Roll over image to zoom in
You dont have to break the loop to make 4-20 mA signal measurements. Exclusive VIP Kit includes FREE Pelican 1450-C Hard case (15 x 10.5 x 6), Black and DC Voltage Detector, 6-50 VDC.
- FREE Pelican 1450-C Hard case (15 x 10.5 x 6), Black and DC Voltage Detector, 6-50 VDC Exclusively from Transcat with purchase of a 773-VIP
>
Overview
Need more hours in your day?
Save time by NOT breaking the loop on 4-20 mA signal measurements.
Are you spending time:
- Taking mA measurements by removing a wire and breaking the loop
- Calling the control room to isolate a loop
- Testing analog input/output on a console
- Troubleshooting devices with mA inputs and outputs
- Repairing intermittent or erratic 4-20 mA loops
- Going back to the shop to get extra tools
>
If you need more time in your busy day take a good look at the Fluke 773 mA Clamp Meters. Its designed to save you time, and money, by eliminating time wasting activities. Now you can troubleshoot and repair 4-20 mA loops without breaking the loop or bringing down the system.
Features
- Best in class 0.2 % accuracy
- 0.01 mA resolution and sensitivity
- Measure 4 to 20 mA signals without breaking the loop
- Measure mA signals for PLC and control system analog I/O
- Dual backlit display with both mA measurement and percent of 4 to 20 mA span
- Measurement Spotlight illuminates hard to see wires in dark enclosures
- Detachable clamp with extension cable for measurements in tight locations
- Measure 10 to 50 mA signals in older control systems using the 99.9 mA range
- Automatically change the 4 to 20 mA output for remote testing
- Power saving features, auto-off, backlight timeout extend battery life
- Hold function captures and displays changing measurements
- Measure 4 to 20 mA signals with in-circuit measurement
- Simultaneous mA in-circuit measurement with 24V loop power for powering and testing transmitters
- Source 4 to 20 mA signals for testing control system I/O or I/Ps
- mA output linear ramp or 25% step output
- DC voltage measurement to verify 24V power supplies or voltage I/O signals
- Source DC voltage to test input devices that accept a 1-5V or 0 to 10V signals
- Scaled mA output provides a continuous mA signal that corresponds to the 4 to 20 mA signal measured by the mA clamp
- mA in/out: simultaneously measure the mA signal with the clamp and source a mA signal
- Voltage output linear ramp or 25% step output
>
Each Unit Includes
- FREE 1450-C Case
- FREE DC Voltage Detector
- Soft carrying case
- Test leads
- Alligator clips
- Hanging strap
- Users manual
